Knitting | Description of Knitting (Production) process

Knitting: Knitting is the interlocking of one or more yarns through a series of loops. The length wise columns of stitches, corresponding to the warp in woven cloth, are called WALES; the cross wise rows of stitches, corresponding to the filling in woven cloth, are called COURSES are those in which the courses are composed of a single strand of yarn, while warp knits are those in which the Wales are composed of single strand of yarn. GAUGE corresponds to the yarn in a woven fabric and is defined as the number of needles of yarns in half inches of cloth. The higher the gauge, the more compact and finer is the cloth.
It is the name of the craft that involves two needles and yarn or thread. Loops in the yarn are manipulated with the needles to make a knitted fabric. The knit stitch is the most basic form of knitting. It involves slipping the needle into the loop from front to back, looping the working yarn around the needle and sliding the stitch through onto the second needle. 

Description of Knitting (Production) process: The process sequences are in list below:

1. Firstly, knitting manager gets a production shift from the merchandiser as accordance as consumer requirements then he informs or production officer about it. 
2. Production officer informs knitting master and knows about machine in which the production will be running. 
3. Knitting master calls for leader of mechanical fitter troops, they two take decision about machine for production considering machine condition, production capacity, maintenance complexity, etc.
4. Production officer with experienced mechanical fitter adjusts required stitch length and grey GSM for required final GSM. 
5. Supervisor checks daily production regularity and make operator conscious about finishing the production schedule in due time. 
6. Operators operate m/c in high attention as if there were no faults in the fabrics. If he thinks or sure about any fabric fault, then he calls for the mechanical fitters in duty. Mechanical fitter then fixes it if he can or he informs knitting master. Then he comes in spot. 
7. After required production and final inspection in 4-points system, they sent in dyeing section.